A. Functions
1. Detection of broken bar
2. Display of the actual number of bars
3. Detection of poor filling of aluminum alloy
4. Simple detection of bar SKEW difference and poor quality of aluminum alloy (While SKEW difference ±5° could be judged)

B. QC Method and operation safety
1. Automatic test mode:
(1) Set up induced voltage high/ low limits and rotor target bar number on HMI base file.
(2) Adjust induced voltage at 1.000V and set up compare voltage on HMI test page, based on the standard UUT.
(3) During test, if there's different reading found other than actual bar number and target bar number, or induced voltage over high/ low limits. So as to determine the existence of broken bars or aluminum poor filling, and aluminum quality as well as SKEW difference detection.
(4) Based on results from above tests, determine whether the rotor passes quality control.
2. Manual judgment: After pressing manual ON switch, the specimen will run continually. Experienced operators may judge from the wave form displayed on the oscilloscope.
3.Safety protection: A light curtain is equipped to protect the safety of the operators. The rotor will automatically stop when the light curtain is interrupted by any obstacles during test.

C. Rotor specification
1. Rotor length: 40 ~120mm
2. Rotor outer diameter: 40 ~120mm
3. Rotor inner diameter: Max. 42mm
4. Rotor slot: Max. 64 slots (Max. weight: 5kg)

D. Rotor drive connection
1. Using balancer drive adopted for the rotor with balancer.
2. Using blade drive adopted for the general rotor.
3. Inward expansion for rotor without balancer or blade.

E. Power supply and air supply
1. Power supply: 3 phase, 220/380V 50/60Hz 1kVA
2. Air supply: above 5kg/cm²

F. Equipment dimension
1. Control panel: 560(W)*610(D)*1650(H) mm
2. Test bench: 560(W)*450(D)*850(H) mm


※We could offer multiple test equipments for different needs.※
※ If you need more information, kindly feel free to contact us.※